Both routers in this example are Cisco 2500 series routers. To copy the Cisco IOS software image from a router that acts as TFTP server to another router see the procedure steps. (38481 bytes/sec) Copy from One Router to Another eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeĮeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeĬopy in progress.CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCĬCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC Source filename ? rsp-jsv-mz.120-8.0.2.T !- Enter the file name of the system image to be copiedĮrase slot1: before copying? Erasing the slot1 filesystem will removeĮrasing device. In this next example, the system image is copied from slot0 to slot1.
The copy command shown next is used to copy the system image file from one device to another. Router# show slot1: !- This command is used to view the contents of slot 1ġ. #- ED -type-crc-seek- nlen -length-date/time- nameġ. This next example illustrates how to copy the system image from one device to another (for example, from one slot/disk to another slot/disk) on Cisco 3600 series routers.ĭetailed Example router# show slot0: !- This command is used to view the contents of slot 0 The three most common commands used to copy images are: Update (merge with) current system configuration Refer to the Configuration Fundamentals Configuration Guide for more information and to learn more about each of these options. Listed in this table are the various locations to which you can copy an image from a TFTP server. The methods can vary based on different platforms. The next table provides command options to use to copy a system image from one device to another. Refer to Cisco Technical Tips Conventions for more information on document conventions. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is not restricted to specific software and hardware versions, but is based on the Cisco 2500 series routers and Cisco 3600 series routers. There are no specific requirements for this document. This document describes how to copy a system image from one device to another within the same router, and from one router to another.
0 kommentar(er)
